| Issue |
Int. J. Metrol. Qual. Eng.
Volume 6, Number 3, 2015
|
|
|---|---|---|
| Article Number | 307 | |
| Number of page(s) | 5 | |
| DOI | https://doi.org/10.1051/ijmqe/2015021 | |
| Published online | 23 October 2015 | |
Interlaboratory comparison in the pressure range from 0 to 2 MPa for accredited calibration laboratories
Laboratory for Process Measurement, Faculty of Mechanical Engineering and
Naval Architecture, University of Zagreb, Croatia
⋆ Correspondence:
lovorka.grgec@fsb.hr
Received:
4
September
2015
Accepted:
6
September
2015
This paper describes procedure and results of the interlaboratory comparison that was organised by Croatian national pressure laboratory (HMI/FSB-LPM) between eight accredited pressure calibration laboratories. Comparison was performed in the gauge pressure range from 0 to 2 MPa with pressure transducer as transfer standard and using gas as transmitting medium. Basic aim of this comparison was to improve measurement methods and the measurement uncertainties of each participating laboratory. Analysis of the measurement results are given by calculating the deviation, En, normalized with respect to the stated measurement uncertainties.
Key words: Interlaboratory comparison / pressure / measurement uncertainty
© EDP Sciences 2015
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.